Expert in Comprehensive PCBA Full-Process Services
Industrial control relays and power chips exhibit poor heat dissipation after soldering and are prone to failure under high-temperature operating conditions. How can this be optimized?
Ensure that the thermal pads are fully tinned, with the stencil apertures covering the entire pad area and incorporating venting holes. Select a high-thermal-conductivity solder paste, and apply industrial-grade thermally conductive silicone grease when necessary. During reflow soldering, control the peak temperature and soak time; after soldering, use a thermal imager to measure the temperature rise, and if the rise exceeds the specification, adjust the amount of solder or replace the solder alloy.
Lead-free soldering exhibits poor wetting and dark, dull solder joints, which fail to meet industrial control reliability requirements. How can this be improved?
Use industrial-grade solder paste with a highly active flux, matched to the plating on component leads. Perform plasma cleaning of pads and leads to remove oxide layers and surface contaminants. During reflow soldering, extend the soak time and appropriately increase the peak temperature (without exceeding the component’s maximum thermal tolerance), followed by thorough removal of residual flux after soldering.
After vibration and high–low temperature cycling in industrial environments, solder joints crack. How can stability be improved?
Select high-tack, industrial-grade solder paste, and apply extra solder to critical joints—such as power connectors and signal pins—to reinforce them. During PCBA layout, mount key components in the board-edge reinforcement zones. After soldering, conduct vibration and thermal cycling tests; for any cracked solder joints, adjust process parameters and, if necessary, perform underfill.
After soldering, the industrial control board connector exhibits poor contact and fails after only a few insertions and extractions. How should this be addressed?
Use industrial-grade, wear-resistant connectors and clean the oxidation layer from the pins before soldering. During component placement, ensure precise alignment; control the reflow soldering temperature to prevent deformation of the connector’s plastic housing. After soldering, verify pin continuity, conduct plug-and-play tests for at least 50 cycles with no abnormalities, and re-solder any loose pins for reinforcement.
Soldering on large copper pads on industrial control boards is insufficient, which affects conductivity and heat dissipation. How can this be optimized?
Create a grid-like aperture pattern in the steel stencil over the copper pad areas to increase solder wetting area and venting. Use a highly active solder paste and extend the soak time during reflow soldering. Prior to soldering, lightly brush-plate the copper pads with solder; after soldering, inspect the uniformity of the solder coverage and perform touch-up soldering where necessary.
A professional EMS (Electronic Manufacturing Service) company dedicated to providing customers with end-to-end manufacturing services, including SMT, DIP, post-soldering, assembly, adjustment, complete-unit testing, and finished-product packaging and shipment.
No.19 ,CHUANG YE 1ST RD,NINGBO,FREE TRADE ZONE(WEST),R.P.O.C